Q&A Improvement Case Studies
Space saving
-
Radiation degrades photomicrosensors fast and we have to replace them every two or three months.2012.09.10
-
Radiation degrades optical fiber sensors. Are there any sensors durable under radiation exposure?2012.09.10
-
The switch is not broken but false signals frequently occurs. It is necessary to detect the opening and closing of disk brake pads without fail!2012.09.10
-
Is there any alternative to contact detection by installing an intermediate unit onto proximity sensors?2012.09.10
-
We have some problems with the presence detection of wafers for semiconductor devices with photoelectric sensors.2012.09.10
-
We need to correct the deviation of printing plates in micron increments.2012.09.10
-
Can 1 mm or smaller slight movements of diaphragms be detected stably with switches?2012.09.10
-
There is no mounting space for a photoelectric sensor in workpiece detection with a robot.2012.09.10
-
We are experiencing problems with connectors for optical fiber sensors inside vacuum film forming equipment.2012.09.10
-
Mutual interference of neighboring proximity sensors prevents stable detection.2012.09.10
-
The intermediate mechanism installed for the detection of screws in pinholes with a proximity sensor costs too much.2012.09.10
-
Are optical fiber sensors the best for glass substrate alignment inside vacuum film forming equipment for FPDs?2012.09.10
- Radiation degrades photomicrosensors fast and we have to replace them every two or three months.
- Radiation degrades optical fiber sensors. Are there any sensors durable under radiation exposure?
- The switch is not broken but false signals frequently occurs. It is necessary to detect the opening and closing of disk brake pads without fail!
- Is there any alternative to contact detection by installing an intermediate unit onto proximity sensors?
- We have some problems with the presence detection of wafers for semiconductor devices with photoelectric sensors.
- We need to correct the deviation of printing plates in micron increments.
- Can 1 mm or smaller slight movements of diaphragms be detected stably with switches?
- There is no mounting space for a photoelectric sensor in workpiece detection with a robot.
- We are experiencing problems with connectors for optical fiber sensors inside vacuum film forming equipment.
- Mutual interference of neighboring proximity sensors prevents stable detection.
- The intermediate mechanism installed for the detection of screws in pinholes with a proximity sensor costs too much.
- Are optical fiber sensors the best for glass substrate alignment inside vacuum film forming equipment for FPDs?